1206 red anti-stick
Manufacturers supply LED lamp bead SMD LED 0805 yellow light super bright indicator light dedicated
The tapped variable inductor and three broadcast tuning capacitors are easily pre-tuned to match the low power transmitter antenna with a common amateur band standing wave ratio of one. The resistor bridge is only used to initially determine the correct C1 and C2, C3 settings and S2 used in each band. Set S1 to n to provide the transmitter's peak output to J1 (5W max) and adjust R4 to the full value of the frequency of use. Repeat the steps to read the M1 value.
The handheld addresser is used to program the address of the monitoring module offline. When in use, connect the two output wires of the handheld encoder to the communication bus terminal (terminal label 1, 2) of the monitoring module, turn on the black power switch on the right side upwards, and press "ten Add", [Subtract ten", [Add one place" and [Subtract one place" to program the address.
Position Encoder,Magnetic Rotary Encoder,Hybrid Encoder,Channel Encoder
Changchun Guangxing Sensing Technology Co.LTD , https://www.gx-encoder.com