Centralized drive installation requirements and technical parameters

Smart Transponder Installation Requirements

Smart transponders are generally ceiling-mounted or wall-mounted. If you install a dual- or tri-functional smart transponder with integrated human motion probe, follow the following guidelines (so that the anti-theft monitoring and automatic lighting control can be reliably performed).

(1) It should be installed in a place where it is convenient to monitor human activities. There should be no screen, large bonsai or other partitions within the scope of detection.

(2) should be 2.0-2.2m away from the ground.

(3) Keep away from air-conditioning, refrigerators, stoves, etc. where the air temperature changes sensitively.

(4) Do not directly face the window, otherwise the disturbance of hot air currents outside the window, instantaneous bright light, and people walking will cause false alarms. It is better to draw the curtains on conditions; and do not install in places with strong air flow.

Centralized drive installation requirements and technical parameters

(5) The smart transponder (with four infrared emission heads) consists of a fixed base, an intermediate base, and an outer cover. Among them, the fixed base is fixed on the ceiling with a screw, the middle base is fixed on the fixed base by a fastener, and the outer cover is buckled on the middle base.

(6) The installation position of the ceiling-mounted smart transponder and the infrared receiver of the home appliance (especially the TV, VCD or audio equipment) should not be vertical. At least an angle of 45° must be ensured. Otherwise, it may not be controlled. Home appliances.

Intelligent forwarding technical parameters

(1) Human detection angle: 90. Within.

(2) Human detection distance:

(3) Infrared forwarding angle:

(4) infrared remote control distance:

Power Cord

A power cord, line cord, or mains cable is an electrical cable that temporarily connects an appliance to the mains electricity supply via a wall socket or extension cord. The terms are generally used for cables using a power plug to connect to a single-phase alternating current power source at the local line voltage-(generally 100 to 240 volts, depending on the location). The terms power cable, mains lead, flex or kettle lead are also used. A lamp cord (also known as a zip cord) is a light-weight, ungrounded, single-insulated two-wire cord used for small loads such as a table or floor lamp.

Power Cord,Home Appliance Power Cord,Power Cable Cord

Dongguan YAC Electric Co,. LTD. , https://www.yacentercn.com

This entry was posted in on