Replace the battery is simple, full of blood rejuvenated Meizu MX3

The leader of the Meizu MX3 battery bulging at home, no longer can not charge electricity, and even the back cover is not tight. Throw it into the drawer and drop it.


Less than three hundred oceans now, when I switched from M9 to MX3 for leaders in 2014, of course, 1799 is now also discontinued.

(Meizu has become a strategy from the niche brand, I do not know how long it can take, as the kerosene from M8 all the way, would like to come to recharge it for the feelings of it)

A few days ago itchy, watching the MX3 is also a pity, I just wanted to change the battery, looked online, the difficulty of changing the battery is still very small.

The leader said that you have completed the maintenance of the previous mobile phone.

This Sony Ericsson mobile phone is always in poor contact with the cable, the official maintenance of the two (design flaws, direct black life), over the protection on their own hands, and the result. . . . . .

Having said that, at first I thought MX3 was MX, because the battery was marked with MX, Meizu customer service said that there is no provision, can not be repaired. Ma could not find a suitable one. Once again looking for information, it was discovered that the battery model M355, confirmed the order.

Express is not a table, hand unpacking is as follows

A set of tools and a battery (it can't be seen, the workmanship is still good,), I asked for a single row of 16G, but with this

NFC interface (more on that later).

Disassemble a total of 13 screws, two of which are hidden under the fragile tamper-resistant stickers (seemingly smaller screws)

Remove the screw, gently glance, the shell can be removed, there is no dark buckle, no bayonet, no double-sided adhesive, it has a full plastic shell.

Exposing the battery capacity and battery cable contacts (red hexagonal ring). The blue circle is NFC, but there are no connector contacts, so the NFC connection on the battery I bought is cut off and glued to the edge of the battery.

The contacts of the original soft-wired wire on the battery can be cut down with nails.

As you can see, the MX3 battery uses double-sided adhesive on the upper fuselage frame structure. From the left side of a small bayonet, you can think of ways to cut down the entire battery, in order to reduce the damage to the fuselage, I use the hair dryer to heat the battery on both sides. Slightly forced down.

How to see how to look like a set of demolition

The rest is to put a new battery in the cat's home, put on the battery cable contacts, tried it, perfect boot.

Shut down again, install the shell, screw up 13 pieces, cover the back cover, perfect hand.

in conclusion:

Meizu this MX3 mobile phone is not difficult to change the battery, a special screwdriver can, and this problem the battery seller will give you a solution. Thanks again to the development of the Chinese Internet and the Ma family.

High cost performance, the official battery 80 +40 yuan artificial, this less than 30 yuan, but also a picture of music, but also to pick it up?  

The proper hands-on DIY in life is also the joy of life, with a smile and ten years






Touch

Mobile Phone Touch Screen

Products black edge is finer and more accurate.

Perfect and exquisite pressing detail process.

Touch Screen

Touch screen is an electronic display that can detect and respond to the touch of a user's fingers or stylus. It allows users to interact directly with the display by touching or tapping on the screen, eliminating the need for a physical keyboard or mouse. Touch screens are commonly used in smartphones, tablets, laptops, and other electronic devices to provide a more intuitive and user-friendly interface.


Touch Panel,Touch Screen Glass,Replacement Touch Screen Glass,Oppo Touch Screen

Dongguan Jili Electronic Technology Co., Ltd. , https://www.jlocaglass.com

This entry was posted in on